streetersuperstands.com
The two short bolts with nuts will be
used to attach the lower portion of the
handle to the bottom of the stand base.
The longer bolt with nut will attach the
handle to the upper portion of the base.
Strip wire ends on the handle wires and
match up wires to those already installed
in the terminal connector. Match the
colored cable ties and match the corre-
sponding wire colors together. DO NOT
remove the colored cable ties.
Yellow colored cable tied red and black
wires should be installed to match those
in the terminal.
Orange colored cable tied red and black
wires should be installed to match those
in the terminal.
Tighten screws and check to make sure
wires are secure within the terminal.
When this is complete, re-install the
cover plate.
Remove nut, bolt and washers from each
of the stands arm assemblies.
Install arm assemblies onto the base and
insert washers, bolt and nut.
Tighten accordingly, though making sure
the arms freely pivot.
