Thread short end of front axle studs into
the stand. The use of a “blue” thread
locker is suggested. Tigthen each axle/
stud.
Install wheels and tighten each axle nut.
Once tightened, back-off (loosen) nut
just enough so the wheel spins freely.
Install casters and tighten mounting bolts. Some users prefer to position the
base of their stand on its side or lay it upside down during this process. While
installing casters, it is a great time to check the tightness of the (4) bolts on
each caster that hold the wheel to the hub -as to verify they did not loosen
during packing and shipping. Casters should be lubed prior to use and
periodically there after for optimum performance.
Remove terminal cover located on the
bottom of the stand base. Notice that
they are together and matched with
colored cable ties. DO NOT remove the
cable ties on these wires!
There should be NO battery or power of
any kind hooked up to the stand at this
time!
Slide wires from handle assembly through
access hole in frame and in to the terminal
connection area. DO NOT remove the colored
cable ties on these wire!
Losen screws on the empty terminal spots.
streetersuperstands.com
