Streck ESR-Auto Plus 506, Operator'S Manual

Page: 47 / 86

ESR-Auto Plus Operator’s Manual 39
6.4 Registering Test Rack
The ESR-Auto Plus test rack is designed to simulate ESR
levels. Each test rack is unique and its reference values
must be registered in the ESR-Auto Plus where the test rack
will be used.
–service menu–
reg test rack?
Press to register the test rack.
Press to advance to the next menu selection.
–new test rack–
sure?
Press to proceed with the registration process.
Press to return to the service menu.
–new test rack–
insert rack [ok]
Insert the test rack and press to begin the registration
process. The instrument will scan the test rack twice
and print the results (Figure 19). Test rack results must
be ±1mm from first read to second read. Test rack results
must be ±2mm from predefined values.
After registering a test rack, a test rack verification will
occur (see Section 4.7).
Press to verify the results.
* ESR-Auto Plus TEST RACK REGISTRATION *
MM-DD-YYYY HH:MM SERIAL NO: 506-0000
SOFTWARE VERSION: V00.0 (YYYY-MM-DD)
TECHNICAL SETUP:
MOTOR SPEED : 12 SEC/R
V-OFFSET : 24 DEG
REF-CYCLE : 5100
IR POWER : 50%
TEST RACK LEVELS: (REAL mm)
1ST READ 2ND READ
POS MM MM
1 8.6 mm 8.6 mm
2 13.0 mm 13.0 mm
3 24.1 mm 24.1 mm
4 34.5 mm 34.5 mm
5 39.7 mm 39.7 mm
6 44.8 mm 44.8 mm
7 49.9 mm 49.9 mm
8 54.5 mm 54.5 mm
9 64.6 mm 64.6 mm
10 74.2 mm 74.2 mm
TEST RACK REGISTRATION OK
Figure 19: Test Rack Registration Report