BATHTUB INSTALLATION
4. Take 2 washers (Part #6) and place 1 washer over
each bathtub bolt.
5. Take 2 nuts (Part #2) and place 1 over each bathtub
bolt. Tighten, but do NOT tighten fully. This is so the
metal bar can be adjusted and slid to accommodate.
6. Take l hex bolt (Part#4) and take l washer
with a large diameter (Part #5) and put the
washer th rough the bolt. Here is how it should
look in your hand:
7. Screw the nut with the washer on top of the
metal bar but do not screw in fully. Leave room
to insert the clawfoot.
4. Take the bolt, nut and screw them into the clawfoot
as shown in the diagram below. Make sure to tighten
the bolt into the clawfoot using the provided hex key.
5. Place the metal plate (Part#2) over the bolts on the
bathtub as shown in the diagram below. Make sure to
adjust the metal plate so that it fits snug with the
bolts on the bathtub. This will help to ensure that the
clawfeet are placed correctly and are functioning
properly.
6. Takel washer (Part#B) and put it over the bolt
on the bathtub. Then take l nut (Part#3) and place
it over the washer, but do not tighten the bolt
completely. Repeat this step for the other bolt on the
bathtub.
©
st
r
earn
l
1
ne
b
ath.com
G
s
uppor
t
@st
r
eam
l1
nebath
.
com
\.
(310) 935
-
0028