M-X5-GUI-8CH-2013_Q3
More information
www.streamaxtech.com
Copyright
2012-2014, Streamax Technology Co., Ltd
All Rights Reserved
All specifications are therefore subject to change without notice.
This function only can be active when the MDVR connected with inertial sensor.
Please note that the GPS antenna should be connected to MDVR to receive
satellite signals for speed.
For more information on capturing speed from speedometer please contact local
distributor for more technical support;
SPD CHECK:
Speed check is used to calibrate the offset speed when connected to the speedometer.
That’s to say, the check only available when speed source is vehicle.
Input the first area with the vehicle speed, for example at 80 (in KM/H)
Start the vehicle and the second area will show the data from speedometer (in HZ)
When the vehicle reach to 80 KM/H (shown in vehicle meter or dash board), and
keep this speed at 30 seconds, then press the “Check” to make the system
calibrate the second area (HZ) set as first area data (80);
SPEED UNIT:
MPH or KPH,
MILEAGE
is the total mileage that the MDVR has run.
OVER SPEED:
If the vehicle exceeds the SPD, MDVR will trigger the alarm signal (when the following option
ALARM set as YES) until the driver slows down the speed
LOW SPEED:
If the vehicle exceeds the high speed limit, MDVR will trigger the alarm signal (when the
following option ALARM set as YES) until the Admin password is entered to acknowledge the
alarm.
3.2.4.4
ACCELERATION
There are 3 values for G force inertial sensor: X, Y, and Z. X indicate forward and backward. X, Y indicates
left and right and Z indicated up and down. Threshold is the limitation for the value, if the value large than the
setting in the menu, then MDVR will trigger alarm.
3.2.4.5 TEMPERATURE
Inspection for temperature, there are high and low two kinds temperature inspection.
