Flaire Issue 1.3 29/06/01
Page 9 of 11
Removal of burner & convection box
1. Turn off the gas supply by the isolation cock.
2. Disconnect the 8mm pipe from the elbow at the left hand side of the burner.
3. Slacken the grub screw and pull off the control knob on the upper right hand side of
the case if fitted. Slacken the two screws underneath the canopy, and slide the
canopy off. Remove the 2 screws securing the front casing (one each side, near the
bottom) and carefully remove the casing by sliding the left hand edge forward, then to
the right to clear the high level tap spindle. Place carefully to one side.
4. Remove the 2 screws securing the burner to the convector box and remove the
burner. For a High Level Control version it will also be necessary to disconnect the
pipes at the gas tap and injector by undoing the union nuts.
5. Remove the 4 screws in the flange of the convection box, and lift the box out of the
opening.
6. Examine the flue for debris and clean if necessary.
7. Reassemble in the reverse order.
8. After servicing check for gas soundness.
Following a service, a check should be made for clearance of combustion products. Follow the
procedure detailed in these instructions.
Cleaning the fire
Black paint:
Use only a clean damp cloth. Do not use any cleaning agents.
Brass parts:
Fret
- Use Brasso or Duraglit ensuring that it does not come into contact with the
black paint finish.
Brass frame
- This has a laquered finish and should only be wiped with a damp cloth. Do not
use metal polish.
IMPORTANT -
The paint finish is durable and heat resistant, however it will be damaged if
plaster, cement or wallpaper paste is allowed to come into contact with it.
Protect the
appliance during re-building or decorating work.
Replacement of parts
Before commencing any servicing always ensure that the fire is isolated from the gas supply
and that the fire is cold. After servicing always check for gas soundness.
Replacement of gas tap/FSD/piezo igniter
1. Turn off the gas supply by isolation cock.
2. Lift off the front fret and remove the coals and ceramic blocks.
3. Proceed with paragraphs 2-4 above, 'Removal of burner and convection box'
4. Pull off control knob.
5. Remove the 2 screws securing the Data Badge plate and remove the plate.
6. Disconnect ignition lead to the igniter unit.
7. Disconnect all gas connections to gas valve as well as the connection to the
thermocouple.
8. Remove 2 screws securing the valve to the mounting bracket, and discard old
tap/FSD/piezo igniter complete.
9. Assemble the new tap/FSD/piezo igniter on the mounting bracket.
Ensure that the
filter is in position in the pilot outlet orifice on the tap body.
10. Reassemble the appliance in reverse order.
11. Replace the ceramic blocks and coals (see Fig. 4).
12. Turn on the gas supply and check for soundness.
Note: The igniter is not replaceable separately.
Replacement of high level gas tap
(High level control version)
1. Turn off the gas supply by isolation cock.
2. Pull off the control knob on the upper right hand side of the case if fitted. Slacken the
two screws underneath the canopy, and slide the canopy off. Remove the 2 screws
securing the front casing (one each side, near the bottom) and carefully remove the
