Stratus ftserver 3300, Site Planning Manual

Page: 30 / 138

Planning for Cables
3-2 Stratus ftServer 3300, 5600, and 6600: Site Planning Guide (R553)
Planning for Cables
To accommodate cables from the ftServer system, make sure to provide:
•
Two telephone lines:
– One telephone line for use when calling for service
– One telephone line for the ASN modem or for the modem in the ftServer
Access Adapters
•
Ethernet jacks, switches, or hubs as needed
•
Two electrically separate grounded AC wall outlets, or a UPS and a wall outlet,
within reach of the power cords from the system or PDUs and any components that
do not connect to a PDU
Make sure that any cables you plan to connect to the system are long enough to reach
between the system and external components or connections.
Table 3-1 lists the
cables Stratus supplies and, for space planning, specifies the lengths of each cable.
Table 3-1. Cables Supplied by Stratus
Component Cable Description Length
V128 1U flat-panel
LCD monitor with
integrated keyboard
and trackpad One VGA cable attached to the LCD monitor and
which connects to the VGA port in the I/O panel 72 in. (183 cm)
One USB cable attached to the LCD monitor and
which connects to another USB cable, which is
connected to the system 72 in. (183 cm)
V129 table top LCD
monitor One VGA cable attached to the LCD monitor and
which plugs into the VGA port in the I/O panel 72 in. (183 cm)
One USB cable attached to the keyboard and
which plugs into a USB port in the I/O panel 72 in. (183 cm)
One USB cable attached to the mouse and
which plugs into the keyboard USB hub 72 in. (183 cm)
T521 or T522
rack-mounted tape
drive enclosure One SCSI-3 high-density cable with one 0.8 mm
VHDC connector and 68-pin SCSI-3 connector,
which connects to the SCSI port on the back of
the I/O enclosure. 10 ft (305 cm)
First T511 or T513
external tape drive One SCSI-3 high-density cable with one 0.8 mm
VHDC connector and 68-pin SCSI-3 connector,
which connects to the SCSI port on the back of
the I/O enclosure. 10 ft (305 cm)
30 ft (915 cm)