Fasten two 10x16 wafer-head tek screws through the
Padbolt Mount Plate and into the Door Sheet. Fasten four
10x16 wafer-head tek screws through the Padbolt and into
the Padbolt Mount Plate.
Figure 3.5
Figure 3.4
Flip over the Door, so that the underside is facing up. Fit the
two Door Braces diagonally across the Door. Drill 3.5mm
holes through the Door Braces and into every second rib of
the Door Sheet, as indicated by the ‘X’ marks below. Rivet
through the Door Sheet into the Door Braces.
Padbolt Mount Plate
Padbolt
Padbolt
Padbolt
mount plate
10x16 wafer-head
tek screw
Fasten three 10x16 wafer-head tek screws through the Hinge
and into the Door Jamb at both ends. Ensure the end of the
Door Jamb is spaced approximately 40mm from the bottom
of the Door Channel.
Figure 3.3
Door Jamb
Hinge
10x16 wafer-head
tek screw
Door Jamb
Hinge
10x16 wafer-head tek screw
40mm
Door Channel
Door Jamb
- Drill holes and rivet
through every second rib
Coloured Rivet
3.5mm Drill
Door Brace
