Fit the Front Flashing onto the Roof Sheets. Fasten seven
10x16 self-drilling screws with washer through the Front
Flashings and into the Side Flashings and Roof Sheets.
Fit the two Roof Braces diagonally across the Roof. Drill
3.5mm holes through the Roof Braces and into every second
rib of the Roof Sheets, as indicated by the ‘X’ marks below.
Rivet through the Roof Sheets into the Roof Braces.
! - To help keep the Roof Brace in position, drill and rivet the
four end holes first. Then drill and rivet the remaining holes.
Flip over the Roof, so that the underside is facing up. Fit the
Pull Cord Latch into the Front Flashing. Ensure a 250mm
spacing from the Pull Cord Latch end to the Side Flashing.
Fasten two 10x16 Wafer-Head Screws through the Pull Cord
Latch and into the Roof Sheet.
Pull Cord Latch
Pull Cord Latch
Front
Flashing
Wafer-head
Tek Screw
Front
Flashing
1.
2.
250mm
Side Flashing
For easy assembly of the Gas Struts, lay the Roof on it’s side.
Fasten two 10x16 self-drilling screws with washers through
the Side Flashing and into the Roof Sheet on both sides.
Fit the slotted holes of the Gas Strut Bracket against the
10x16 self-drilling screws, ensuring the Gas Strut Bracket is
aligned to the middle of the Roof Sheet pan.
Fasten the 10x16 self-drilling screws to the Gas Strut Bracket.
POOL PUMP FILTER STORAGE SHED INSTALLATION GUIDE
Figure 1.3
10x16 self-drilling screw
with washer
Right Flashing
Left Flashing
Front Flashing
Front
Flashing
Roof Sheet
Strut Bracket
10x16 self-drilling
screw with washer
Side Flashing
Gas Strut
Nut facing outwards
Roof Brace
Drill holes and rivet
through every second rib
Coloured Rivet
3.5mm Drill
!!
!!
!!
!!
!!
Drill and rivet first
Figure 1.6
Figure 1.5
Figure 1.4
