10x16 wafer-head
tek screw
Pull Cord Latch
Mark from
previous step
Door Jamb
From the outside of the shed, align the Pull Cord Latch with
the mark from the previous step. Fasten two 10x16 wafer-
head tek screws through the Door Jamb and into the Pull
Cord Latch.
Figure 4.20
Piping
Wall Channel
Measure and Cut
Figure 4.22
Rivet the Supplied Hole Cover Sheets to the Wall Sheets to
cover up the remaining gaps for a neat finish. Reinstall the
Wall Channel
You may have piping that extends out from the Pool Pump
Filter Shed. If so, follow the steps in figures 4.21 to 4.22.
Measure and mark the location of the piping on the Wall
Sheet. Use Tin Snips to cut out the required hole.
Remove the Bottom Wall Channel and lower the Shed in
position over the piping.
Figure 4.21
Hole Cover Sheet
Wall Channel
Figure 4.19
Fit the Pull Cord Latch up against the Wall Sheet and Door
Jamb. Pull the Pull Cord Latch tight (downwards) and mark
the Pull Cord Latch position on the Door Jamb.
Mark this point
Pull Cord Latch
Wall Sheet
Door Jamb
