11
www.strata.co.nz
ADVANCECUT 65
Care & Maintenance
Keep your Plasma Cutter
in Top Condition
The ADVANCECUT 65 does not require any special
maintenance, however the user should take care of
the machine as follows:
• Regularly clean the ventilation slots.
• Keep the casing clean.
• Check all cables before use.
• Check work leads/clamps and torches before use.
• Replace worn earth clamps that do not provide
a good connection.
• Replace worn consumable parts in a timely
manner.
• Use a soft cloth or brush to clean electrical
components.
• Do not use liquid cleaning products, water or
especially solvents.
• Do not use compressed air to clean electrical
components as this can force dirt and dust
further into components, causing electrical short
circuits.
• Check for damaged parts. Do not use the plasma
cutter with damaged parts.
• A damaged plasma cutter must be carefully
checked by a qualified person to determine that
it will operate properly. Check for breakage of
parts, mountings and other conditions that may
affect its operation. An authorised service centre
should properly repair a damaged part. Have your
machine repaired by an expert.
This appliance is manufactured in accordance with
relevant safety standards. Only experts must carry
out repairing of electrical appliances, otherwise
considerable danger for the user may result. Use only
genuine replacement parts. Do not use modified or
non-genuine parts.
Storing the Plasma Cutter
When not in use the plasma cutter should be stored in
a dry and frost-free environment.
WARNING!
Before performing cleaning/main-
tenance, replacing cables / connections , make
sure the welding machine is switched off and
disconnected from the power supply.
