Method 2:
Housing unit with internal
height less than 710mm.
Note:
You will not need the 2 side
trims (692mm long) or the appliance
runners for this installation. You will
need the 2 runners to fix to the
adjacent cabinets.
Before you start - make sure, before
removing the bottom shelf or modifying
the housing unit, that it will remain
structurally sound - eg; by fixing to
adjacent cabinets, floor or worktop.
There must be enough space at the
back of the oven for the gas inlet pipe
to hang clear of any obstructions.
You may have to cut into, or remove,
any rear cross members from the
housing unit too obtain the 570mm
minimum depth.
To obtain the required 715mm height,
you may have to lower or remove the
bottom shelf, remove any cross rails
and reposition brackets.
Fix the runners:
1. Take the side trim, hold it against
the side of the base unit, and use
it to mark off 692mm from the top
edge of the side unit to the top
edge for the runner.
Note: This ensures a 5 - 8mm
clearance from the underside of the
worktop to the top of the appliance.
2. Measure 50mm from the front
edges of the base units, to mark
the front edge for the runners.
3. Take 6 of the n˚ 8 x 12mm (black)
chipboard screws and screw the
runners into position the right way
up as shown.
4. If necessary, adjust the height of
the plinth to just below the bottom
edge of the runners.
26
INSTALLATION INSTRUCTIONS
