StorageWorks RAID Array 410, Installation Manual

Page: 26 / 48

Chapter 2. Creating an Initial Configuration
EK–SMRA3–IG. C01 2–13
Next, verify the StorageSets you have configured:
SWXRC> SHOW STORAGESETS
The controller responds with a display similar to that shown below:
Name StorageSet Uses Used by
STRIPE_MIRROR stripeset MIRROR_SET_3 D500
MIRROR_SET_4
STRIPE_SET_1 stripeset DISK110 D2
DISK210
DISK310
MIRROR_SET_1 mirrorset DISK120 D400
DISK220
MIRROR_SET_3 mirrorset DISK320 STRIPE_MIRROR
DISK420
MIRROR_SET_4 mirrorset DISK520 STRIPE_MIRROR
DISK620
RAID_SET_1 raidset DISK100 D0
DISK200
DISK300
RAID_SET_2 raidset DISK400 D1
DISK500
DISK600
SPARESET spareset DISK610
FAILEDSET failedset
JBOD devices are not displayed in this report. To display JBOD devices, enter the following:
SWXCR> SHOW DEVICES
Record the above information in the following table. In the event of a controller failure, the
information that is recorded here will assist you in reconstruction of the storageset on your
RAID Array 410.