Command Syntax
The following is the syntax of the DESELECT command:
DESELECT device_name
The symbol
device_name
refers to a valid MSCP/TMSCP device label for either
a direct access or sequential access device. Direct access devices, such as disk
drives, are specified with the ‘‘DIA’’ prefix to the device label, for example,
‘‘DIA100’’. Sequential access devices, such as tape drives, are specified with
the ‘‘MUA’’ prefix, for example, ‘‘MUA120’’.
Example 3–4 is an example of the DESELECT command.
Example 3–4 DESELECT Command
UTILIT> DESELECT DIA100
UTILIT>
3.1.4.5 The ABORT Command
Use the ABORT command to terminate the QUALIFY, DISKTEST, and
TAPETEST operations. These operations normally run until stopped with the
ABORT command or by powering off the HSD05 array controller.
Command Syntax
The following is the syntax of the ABORT command:
ABORT device_name
The symbol
device_name
refers to a valid MSCP/TMSCP device label for either
a direct access or sequential access device. Direct access devices, such as disk
drives, are specified with the ‘‘DIA’’ prefix to the device label, for example,
‘‘DIA100’’. Sequential access devices, such as tape drives, are specified with
the ‘‘MUA’’ prefix, for example, ‘‘MUA120’’.
Example 3–5 is an example of the ABORT command.
Example 3–5 ABORT Command
UTILIT> ABORT DIA100
UTILIT>
3.1.4.6 FORMAT
After a device is selected with the SELECT command, you can use the FORMAT
command to perform a format operation.
Operating the HSD05 Array Controller 3–7
