3.1.1 Starting UTILIT from the Console Prompt on OpenVMS VAX Systems
Use the following procedure to start UTILIT from the console prompt on
OpenVMS VAX systems:
1. At the console prompt, enter the SHOW DEVICE command as shown in the
following example:
>>> SHOW DEVICE
DSSI Node ID 0 (DSSI nodename)
-DIA200 (RF72)
-DIA210 (RF72)
-DIA250 (RF72)
DSSI NODE ID 5 (*)
UQSSP Disk Controller 0 (772150)
-DUA0 (RA82)
Ethernet Adapter
-ESA0 (08-00-2B-13-80-85)
This is the HSD05 array controller. The
DSSI nodename
is initially a
six-digit number. Do not confuse this number with the DSSI ID value.
2. Depending upon your installation, enter one of the following two command
lines to use the DUP utility to establish a connection to the HSD05 array
controller:
>>> SET HOST/DUP/DSSI a
Starting DUP server...
Copyright (C) 1994 Digital
HSD05
Serial No: 8
Firmware Rev. B1
(X36 )
DIRECT V1.0
D
Dec 21 1993 16:59:31
PARAMS V1.0
D
Dec 21 1993 16:59:31
UTILIT V1.0
D
Dec 21 1993 16:59:31
End of directory
Task Name?
where
a
is the DSSI ID of the HSD05 array controller.
You may have to explicitly specify the DSSI bus (0 or 1) to properly establish
a connection to the HSD05 array controller. In such cases, use the following
command line:
>>> SET HOST/DUP/DSSI/BUS:n a
Starting DUP server...
Copyright (C) 1994 Digital
HSD05
Serial No: 8
Firmware Rev. B1
(X36 )
DIRECT V1.0
D
Dec 21 1993 16:59:31
PARAMS V1.0
D
Dec 21 1993 16:59:31
UTILIT V1.0
D
Dec 21 1993 16:59:31
End of directory
Task Name?
where:
n
is the DSSI bus ID number (0 or 1).
a
is the DSSI ID for the HSD05 array controller.
3–2 Operating the HSD05 Array Controller
