8
Figure 6
3.
Weld the Angle Seats (No. 16) on each container and use Ropes (No. 14) to knit the cover on
the two side arches, finally tie the Roof cover to the Angle seats.
4.
Cut
pockets
over each ratchet on the base plates and put the Tensioning Tube for roof cover
(No. 10) into the pocket of roof cover. Then use the Nylon band (No.9) to tie down the Lower
Tensioning Tubes as Figure 6 shown. Finally install the
∮
32 Plastic Plug (No. 15) into two end
of the Lower tensioning tube.
Please check the below installation detailed pictures:
(A)
(B)
