Stoneridge SE5000, Control Manual

Page: 27 / 34

Display Messages
Display Messages
There are four type of messages that can be seen on the display.
l
Messages - contains information on processes or reminders to the driver. Messages are not stored and can
not be printed. Press the Back button to clear the message.
l
Pre-warnings - appear as early reminders to the warnings. Pre-warnings are stored and can be printed. Press
the OK button twice to clear the Pre-warning.
l
Warnings - appear in the event of e.g. overspeeding or violations of the law or if tachograph not can be
recording. Warnings are stored and can be printed. Press the OK button twice to clear the Warning.
l
Faults - are more critical than warnings and are displayed if there is a fault detected in the tachograph, in the
sensor or driver card. In addition faults are presented if tampering with the equipment is detected. Faults are
stored and can be printed. Press the
OK button to acknowledge the Fault.
Display Description Action
Message
Entry not possible while driving. Related to
the operator. Stop the vehicle and try the entry again.
If the symbol still is present when vehicle
stopped, disconnect and reconnect the
tachograph and retry.
If the symbol still is present after recon-
nect, tachograph must be decom-
missioned.
Activation
Message
The tachograph is being activated for use
(Workshop card).Related to the tachograph Wait until the automatic activation is
completed.
Activation
complete
Message
The tachograph activation process has been
completed (Workshop card).Related to the
tachograph
Activation
failed
Message
The tachograph activation process has failed
(Workshop card). Related to the tachograph Eject the workshop card from the tacho-
graph.
Check system connections.
Re-insert the workshop card to retry
the activation.
Disconnect the tachograph for 30 sec-
onds and retry.
If the tachograph will not activate it must
be decommissioned and replaced.
Already in
calibration mode
Message
Two workshop cards inserted. The second
card will be ejected without being processed
(authenticated). Related to the operator.
Insert only one Workshop card.
Card 1
fault
Fault
The card in tray 1 is defective. Similar mes-
sage for tray 2. Related to the card. Eject the card and check it visually.
Check the tachograph with a functional
card.
Card 1 time
overlap
Warning
The last withdrawal time of the inserted
driver card is later than the date/time of the
tachograph. Related to the tachograph. Check the date/time of the tachograph
and change if necessary.
Wait for the overlap period to elapse.
If UTC time differs more than 20 min-
utes, a calibration has to be performed.
- 25 -