This section will provide step-by-step instructions for initial system configuration and hard-
ware setup of the StoneFly USO-HA™.
1.
Connect both power supply modules to a power outlet using the included power
cords.
2.
Connect an Ethernet cable to the Ethernet port as shown in picture below:
3.
Turn on the power switch in front of the box.
4.
Configure a computer to be able to access subnet DHCP since the default IP
address for the StoneFly USO-HA™ is set to DHCP.
5.
A monitor is not needed to access the StoneFly USO-HA™, but if you have a
monitor hooked up to the box, you will see when the box is ready for access.
6.
Open a web browser and in address bar, type in
http://DHCP_IP
and hit
return
.
You will see a screen like the one shown below:
USO-HA
™
Power Up and Initial Access
USO-HA
Quick Start Guide
15
Figure 10: System Connections.
