StoneAge TORUS TR-130, User Manual, Page: 6 / 36

6 866-795-1586 • WWW. STONEAGETOOLS.COM
TORUS TR-130 OPERATION
OPERATION:
1. Before use, confirm that the installed manifold is the one specified for the operating pressure and flow rate.
Failure to use the correct manifold will result in an over-speed condition causing permanent component
damage, or a condition in which the tool rotates very slowly or not at all.
2. The MANIFOLD AND NOZZLE SELECTION chart below shows the correct manifold to use for various pressure
and flow combinations. Make absolutely certain that the two nozzles being used are of equal size and in good
condition, otherwise the Torus may rotate erratically, too fast, or not at all.
3. To use the chart, first select the operating pressure row from the left. Move to the right across the table until
you read the flow closest to actual. Located directly under the flow rate is the appropriate manifold type, and
located at the top of this column is the appropriate nozzle size. If you know the pressure and nozzle size, select
the operating pressure row to the left, and read across the nozzle sizes in the top boxes until you get to the
nearest nozzle size. The box where these two intersect will give the appropriate flow rate and manifold type.
MANIFOLD AND NOZZLE SELECTION
CHART
Pr
essur
e & Flow & Manifold Size
OCV Carbide Nozzle Size
Nozzle Size .036 .039 .043 .047 .055 .062 .067 .073 .078 .089 .093 .106 .125 .140 .156
2k psi
138 bar
gpm 48 58
l/min 182 220
Manifold R150 R150
5k psi
345 bar
gpm 20 24 30 35 44 58
l/min 76 91 114 133 167 220
Manifold R150 R150 R90 R90 R90 R90
10k psi
690 bar
gpm 12 16 20 24 28 32 42 46 60 66
l/min 45 61 76 91 106 121 159 174 230 250
Manifold R150 R150 R150 R90 R90 R90 R50 R50 R50 R30
15k psi
1035 bar
gpm 10 11 13 19 23 30 33 37 48 58 70
l/min 38 42 49 72 87 114 125 140 182 220 265
Manifold R150 R150 R150 R90 R90 R50 R50 R50 R50 R30 R30
20k psi
1380 bar
gpm 11 12 14 17 24 30 34 40 46 60 66
l/min 42 45 53 64 91 129 114 151 174 227 250
Manifold R150 R150 R150 R90 R90 R50 R50 R50 R50 R30 R30
R30
50-80 gpm
(190-303 lpm)
R50
28-55 gpm
(106-208 lpm)
R90
16-30 gpm
(61-114 lpm)
R150
10-18 gpm
(38-68 lpm)
TR130 240-RXX-X MANIFOLD TYPES
There are four manifolds for the Torus; select the proper version for the
operating conditions. Different arm lengths are also available .
THIS TABLE SHOWS MANIFOLD AND NOZZLE SIZE SELECTION GUIDELINES FOR COMMON JETTING
SCENARIOS AND DOES NOT TAKE INTO ACCOUNT HOSE SIZE.
For the most accurate manifold and nozzle selection, use the StoneAge Jetting App:
http://jetting.stoneagetools.com