StoneAge Sentinel LWPS-100-X, User Manual

Page: 14 / 32

14
866-795-1586 • WWW.STONEAGETOOLS.COM
MAINTENANCE SHOTGUN MOUNT INSTALLATION
INSTALL SHOTGUN MOUNT
(FOR USE WITH BARRACUDA OR SPITFIRE TOOL)
1. Set the desired Clamp Angle.
• The Clamp Assembly on the Shotgun Mount can
be rotated 30° Up or Down by removing the two
SHCS Screws with a 5/16” Allen Key, rotating the
Clamp into the desired position, and fastening the
Screws in the desired location.
• Make sure these screws are tightened
before operation.
2. Install Shotgun Mount onto the Vertical Carriage.
• Pull to open the Clamp Handle on the Vertical
Carriage and slide the Shotgun Mount in back to
front.
• The mount will stop when it reaches the chamfers
at the front. This is a safety feature.
• Lock the Clamp Handle in place when the mount
is in position.
• If the Clamp Handle feels too loose or too tight, it
can be adjusted with a 5mm Allen Key. Follow the
instructions on the decal on the Vertical Drive.
3. Fasten the Shotgun tool in the Clamp.
• Loosen the two Hex Bolts on the Clamp with a
9/16” Hex Wrench.
• Slide the tool in back to front and securely
tighten the Hex Bolts.
5/16” ALLEN
KEY
MOUNTING
POSITIONS
TENSION
ADJUSTABLE
WITH 5mm
ALLEN KEY
CHAMFER
STOP
PULL OPEN /
PUSH CLOSED
9/16” HEX
INSTALLED
CLAMP
ASSEMBLY