StoneAge AUTOBOX ABX-2L, User Manual

Page: 10 / 36

10
866-795-1586 • WWW.STONEAGETOOLS.COM
1. Mount the appropriate frame Positioner Clamps to the tube
bundle as shown on the previous page. (Shown in Figure
1 with Slotted Quick Clamps) Positioner Clamps should be
aligned horizontally with the direction of the tube rows.
(Figure
1)
NOTE: Heat exchanger tube bundle face, shown for
graphic representation only. Not included in assembly.
2. Insert the Top Rail (slots facing out) into the upper mounting
brackets. If the rail is not closely aligned with the tube rows,
loosen one of the upper mounting brackets and adjust until
the top rail is parallel with the horizontal tube rows. Tighten the
clamps securing the rail to the mounting brackets, and ensure
upper mounting brackets are securely clamped or bolted to
the tube bundle flange.
(Figure 2)
3. Insert the Lower Rail (non-slotted) into the lower mounting
brackets. It is not critical that this rail is aligned as precisely as
the top rail, but it should be close to parallel with the top rail for
best performance. Tighten the clamps securing the rail to the
mounting brackets, and ensure lower mounting brackets are
securely clamped or bolted to the tube bundle flange.
(Figure
3)
4. Loosen the Quick Adjust Handle and pull the gearbox away
from the carriage plate. This will allow the Horizontal Drive
Carriage to slide onto the rail without pneumatic power to
rotate the drive. Center the carriage on the top rail and push
the gearbox back toward the carriage plate. This will engage
the gear into the rail slots. Verify the gear is engaging the slots
correctly and retighten the adjustable handle.
(Figure 4)
LIGHTWEIGHT POSITIONER STEP BY STEP SET-UP
LIGHTWEIGHT POSITIONER SET-UP
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4