Stone SAW DEVIL CS1, Operator'S Manual

Page: 27 / 32

- 27 -
Lubrication
• Check oil levels, wiring, hoses (air, fuel,
water) and lubricate machine daily.
• Repair or replace all worn or damaged
components immediately.
• Check drive belt tension, do not over-
tension.
• Make sure machine has full set of matched
belts.
• Check bladeshaft, make sure arbor and
threads are not worn, damaged, or bent.
• Bladeshaft bearings should be tight, no free
play side-to-side or up and down.
• Grease blade shaft bearings daily.
• Blade collars should be clean, free of nicks
and burrs. No diameter wear and not out of
round.
• Drive pin not excessively worn or bent and
free of gouges.
• All guards in place and secure.
• All fasteners tight and secure.
• Air filter/oil filter (hydraulic or engine)
clean.
• Flush clean water through the pump and
spray the assembly every night. This
prolongs the pump and blade life.
Lubrication and Service
Lubricants:
Engine Oil SAE 10W/30 see engine
manual
General Grease #1 Lithium
Model 6 Transmissions CSP3 Any SAE20W20
• Clean machine before starting lubrication
maintenance.
• Insure machine is on solid, level ground
before starting maintenance.
• During lubrication maintenance insure strict
cleanliness is observed at all times.
• To avoid the risk of accidents, use the correct
tool for the job and keep tools clean.
• The draining of engine oil is best carried out
when the oil is warm NOT hot.
• Any spilled oil must be cleaned up immedi-
ately.
• Use only clean containers for oil and only
CLEAN, FRESH oils and grease of correct
grade.
• Contaminated Water/Fluids/Oils/Filters Must
Be Disposed of Safely.