Stone SAW DEVIL CS1, Operator'S Manual

Page: 12 / 32

- 12 -
Technical Data
ALL SAWS
All saws set RPM at 3200 +/- 50 (no load).
Check blade clamp hub face run-out with
indicator and magnetic chuck. Run-out not
to exceed .015.
Check belt tension.
Belt deflection = .19 inches at 4.2 lbs. for
used belt and 6.2 lbs for new belt.
Grease all pillow blocks.
Apply never-seize to acme screws.
CS2
Make sure kill switch is functional while
running.
CS2 / CSP3
Check depth gauge making sure knob turns
when lift crank is run up and down.
Check choke and throttle action.
CSP3
Run transmission with shifter making sure
neutral correlates with neutral at shifter.
(Adjust at clevis and/or at cable bracket
on transmission mount).
Set drive axle load springs at 2.38 +/- .06
inches when axle is in run position.
While engine is running, check wet/dry
switch for function. (Dry should run—wet
should kill engine).
Check water pump switch for function.
Check engage/disengage lever. Drive
axle to have .13 minimum clearance to
wheel when disengaged.
For longest service life, use any SAE 20W20
in transmission.
Service Check List