35
The programming phase is divided into 3 parts:
1. Memorisation of the transmitters
2. Programming of positions “0” and “1”
3. Optional
programming
The memorisation phases must be performed as indicated in table A1 to ensure that a transmitter can control a MOVENO DSRC-E motor.
WARNING:
•
All the memorization sequences are timed, that is, they must be completed within the programmed time limits.
• For transmitters with multiple “groups”, choose the transmitter group the motor must be associated with before proceeding with the
memorization phase.
•
Programming via radio may be done on all the receivers within the range of the transmitter; therefore, only the one involved in the operation
should be kept switched on.
It is possible to check if the motor already has transmitters memo-
rized; this is done by checking the number of beeps when the motor
is switched on.
4) Programming
2 long beeps
No memorized transmitter
2 short beeps
There are already transmitters memorized
Control of the memorized transmitters
1.
Connect the motor to the power supply, 2 long beeps will be heard immediately
2.
Within 5 seconds press and hold button
■
of the transmitter to be memorized
(for approx. 3 seconds).
3.
Release
button
■
when you hear the first of the 3 beeps confirming memorization
See table A2 for the memorization of additional transmitters
4.1) Programming the transmitters
Table “A1”
Memorizing the first transmitter (in Mode I)
Example
1.
Press and hold down button
■
of the new transmitter (for approx. 5 seconds)
until you hear a beep then release it.
2.
Press
button
■
of a previously memorized transmitter slowly 3 times.
3.
Press
button
■
on the new transmitter again. Release button
■
when you hear the
first of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
Table “A2”
Memorizing additional transmitters (Mode I)
Example
New
Old
New
5s
X3
3s
When one or more transmitters have already been memorized, others may be enabled as shown in table A2.
www.stobag.com
GB
Table “A2 -1” Memorizing a sensor (Mode I)
Example
“P1”
Old
5s
X3
1.
Press and hold down button
P1
of the new sensor (for approx. 5 seconds)
until you hear a beep then release it.
2.
Press
button
■
of a previously memorized transmitter slowly 3 times.
3.
Press
button
P1
on the new sensor again. Release button
P1
when you hear the
first of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
MOVENO_DSRC-E.indd 35
MOVENO_DSRC-E.indd 35
1.12.2011 15:48:13 Uhr
1.12.2011 15:48:13 Uhr
