STMicroelectronics STM3210E-EVAL, User Manual

Page: 20 / 48

Connectors UM0488
20/48 Doc ID 14220 Rev 5
3.8 Daughterboard extension connectors CN10 and CN11
Two 70-pin male headers CN10 and CN11 can be used to connect a daughterboard or
standard wrapping board to the STM3210E-EVAL evaluation board. All total 112 GPI/Os are
available on it. The space between these two connectors and the position of power, GND
and RESET pins (marked in gray in
Table 23 and Table 24 ) are defined as a standard which
allows to develop common daughterboards for several evaluations boards. The standard
width between CN10 pin1 and CN11 pin1 is 2700 mils (68.58 mm). This standard is
implemented on the majority of evaluation boards.
Each pin on CN10 and CN11 can be used by a daughterboard after disconnecting it from
the corresponding function block on the STM3210E-EVAL evaluation board, as described in
Table 23 and Table 24 .
Table 23. Daughterboard extension connector CN10
Pin # Description Alternative function
How to disconnect from function block on
STM3210E-EVAL board
1 GND - -
3 PC7 MC/Smartcard
Disconnect STM3210E-EVAL evaluation board from
motor power drive board.
Keep JP16 on open.
5 PC9 MicroSD Card Remove SD Card from MicroSD Card connector.
7 PA9 UASRT1_TX -
9 PA0 MC/Wakeup/USART2_CTS Keep JP4 on open.
11 - - -
13 PA12 USB_DP Remove R82.
15 PA14 Debug_TCK -
17 PC10 IrDA_TX/MicroSDcard_D2 Remove SD Card from MicroSD Card connector.
19 GND - -
21 PD0 FSMC_D2 -
23 PE2 Trace_CLK/FSMC_A23 -
25 PD2 MicroSDcard_CMD/MC
Disconnect STM3210E-EVAL evaluation board from
motor power drive board.
Remove SD Card from MicroSD Card connector.
27 PD4 FSMC_OEN -
29 PD6 FSMC_WAITN -
31 PD7 FSMC_EBAR0 Remove R22.
33 PG10 FSMC_EBAR2 Remove R15.
35 PG12 FSMC_EBAR3 Remove R77.
37 PG14 Joystick_Left Remove R102.
39 GND - -
Downloaded from Elcodis.com electronic components distributor