Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 7
Rev: V1
Date:102722
®
Part Five: AM / FM Antenna Adapter (BAA22)
Part Four: CAN T-Harness (
JK07-CAN-HAR or JK14-CAN-HAR
)
Step 1
Connect the BAA22 Antenna
Adapter to the factory antenna
cable (white connector).
Note: The mustard colored
antenna cable is for satellite radio.
These are the in-vehicle connections for
the basic installation. If adding cameras,
amplifiers or external microphone, those
connections should be made at this point,
before mounting the radio module.
Section 2: In-Vehicle Harness Connections and Preparation (cont.)
2011-2013 Models: On the wire
harness running below the steering
column, locate the black 2-pin
connector shown. Unplug the
connector and plug each end into
the matching connector on the
JK07-CAN-HAR T-Harness.
2014-2018 Models: On the wire
harness running below the steering
column, locate the gray 2-pin
connector shown. Unplug the
connector and plug each end into
the matching connector on the
JK14-CAN-HAR T-Harness.
Once the CAN T-Harness is
connected, route the 2-pin twisted
lead up to the radio opening,
coming out behind the metal radio
bracket. Secure the CAN harness
with zip ties.
Step 2
Step 1A
Step 1B
OR
