Stinger GOLD STINGER X5, User Manual

Page: 16 / 37

- Installing Search Coils: When the Loading
screen appears, after factory reset, we
make sure that the coil properly connected
to the device, quickly; we raise the device
horizontally in the air, so that it is parallel
to the user's arm, then immediately and
continuously press the Down/ Disc. button
from the main control panel, the device
will start recognizing the attached
Note:
During the ground balancing of the device, it is always preferred that the distance
between the surface of the ground and connected search coil of the device being used
should be 5 to 10 centimeters maximum. Our experts also advise to reset the ground balance
again if the device is giving wrong or inaccurate data.
- Ground Balance Adjustment: After the first factory reset, then connecting
the search coil correctly, and loading it into the device. We lower the device
from the air perpendicular to the ground, so that the coil connected to the
device is horizontal with the surface of the ground, as shown in the above
drawing. To make a correct ground balance: move the device steadily from
right to left or from front to back and vice versa; until a fixed number appears
on the Ground Balance screen, the device will make a distinctive beep sound
indicating that the Gold Stinger X5 has the correct ground balancing.
coil, wait a while for the coil to complete loading, then the device will make
a distinctive sound indicating that the attached search coil has been recog-
nized. Then lower the device at a level of 5 to 10 cm from the surface of the
ground vertically, to start balancing the ground, as shown on the side.
2. Step Two: Install and Load Coils
3. The third step: adjust the ground balance
Incorrect use Correct use
Ground Balance
14
Ground Balance
Notes about research