Still FXH 20N, Original Instructions Manual

Page: 50 / 130

Operation of operator pres-
ence detection
The truck is equipped with two operator pres-
ence detectors:
●
The chair (2)
●
The presence pedal (1)
These two components are truck safety devi-
ces.
First, the forklift operator must sit on the chair
(2). The operator detection contact is then ac-
tivated.
The forklift operator presence pedal (1) must
then be depressed before and while the truck
is moving.
The pedal allows you to operate all the con-
trols of the truck.
In reverse travel (load-arms direction), it is
possible to rise from the chair in the event of
poor visibility. The truck then travels at
2 km/h. The forklift operator presence pedal
must be kept depressed.
Before rising from the chair, it is essential to
slow down the truck to a very low pace and to
check the working environment.
WARNING
Risk of injury
Do not rise from the chair when the truck is travelling
at full speed.
NOTE
Do not rise from the chair to slow down the
truck.
If the forklift operator sits down again, the
truck continues to travel at a limited speed.
The drive switch must be released. When the
forklift operator presses the drive switch, the
truck returns to its normal speed.

Use
4
Operation of operator presence detection
40 11548011651 EN - 02/2021 - 09