0478 131 8365 C - EN
30
Starting routing with an external
docking station:
Fasten the perimeter wire (1) to the ground
on the
left
or
right
as appropriate, behind
the floor plate, directly next to a wire outlet,
using a fixing pin (2).
Provide a free wire end (1) with a length of
approx.
2 m
.
Route the perimeter wire (2) in front of and
behind the docking station (1) with 50 cm
of clearance and at right angles to the floor
plate. A corridor can then be installed
(
12.11) or the edge of the mowing area
followed with the perimeter wire.
A freely travellable area with a minimum
width of 40 cm must be available to the
side of the floor plate (3).
Wire routing in the mowing area:
Route the perimeter wire (1) around the
mowing area and around any obstacles
(
12.9) and fasten it to the ground using
fixing pins (2). Check the clearances using
the iMOW® Ruler. (
If offset drive home (passage) is
used, the perimeter wire must be
routed at least
1.5 m
in front of and
behind the docking station in a
straight line and at right angles to
the floor plate. (
Further information on installation
of the external docking station is
contained in the "Installation
examples" section. (
The robotic mower must not be
more than 17 m from the perimeter
wire at any point, as this would
prevent the wire signal being picked
up.
Summary of Contents for RMI 522 C
