Stihl MSE 220 C, Instruction Manual

Page: 5 / 40

MSE 220 C
English
3
Make sure that the conductor cross
section (wire gauge) of extension cords
meets the minimum requirements – see
chapter on "Connecting to Power
Supply".
Only use tools, guide bars, chains, chain
sprockets and accessories that are
explicitly approved for this power tool
model by STIHL or are technically
identical. If you have any questions in
this respect, consult a servicing dealer.
Use only high quality parts and
accessories in order to avoid the risk of
accidents and damage to the unit.
STIHL recommends the use of STIHL
original tools, guide bars, chains, chain
sprockets and accessories. They are
specifically designed to match your
model and meet your performance
requirements.
Never attempt to modify your power tool
in any way since this may increase the
risk of personal injury. STIHL excludes
all liability for personal injury and
damage to property caused while using
unauthorized attachments.
Do not use a pressure washer to clean
the power tool. The solid jet of water
may damage parts of the power tool.
Do not spray the power tool with water.
Clothing and Equipment
Wear proper protective clothing and
equipment.
Avoid clothing that could get caught on
branches or brush or moving parts of the
machine. Do not wear a scarf, necktie or
jewelry. Tie up and confine long hair
(e.g. with a hair net, cap, hard hat, etc.).
STIHL offers a comprehensive range of
personal protective clothing and
equipment.
Transporting the Power Tool
Before carrying the saw, even for short
distances, switch it off, engage the chain
brake, fit the chain scabbard and
remove the plug from the wall outlet.
Always carry the power tool by the front
handle, never by the power cord,
keeping the guide bar behind you.
Transporting by vehicle: Properly secure
your power tool to prevent turnover,
chain oil spillage and damage.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
–
Voltage and frequency of the
machine (see rating plate) and the
voltage and frequency of your
power supply must be the same.
–
Check the connecting cord, plug,
extension cord and safety devices
for damage. Never use damaged
cords, couplings and plugs or
connecting cords that do not comply
with regulations.
–
The plugs and couplings of
extension cords must be
splashproof.
–
To reduce the risk of stumbling,
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
–
Switch/trigger locked in position
when lockout button is not
depressed.
–
Check operation of chain brake,
front hand guard
–
Correctly mounted guide bar
–
Correctly tensioned chain
–
Never attempt to modify the controls
or safety devices in any way.
Clothing must be sturdy
but allow complete free -
dom of movement. Wear
snug-fitting clothing with
cut retardant inserts – an
overall and jacket combi
-
nation, do not wear a
work coat.
Wear steel-toed safety
boots with cut retardant
inserts and non-slip
soles.
Wear a safety hard hat
where there is a danger
of head injuries from fall -
ing objects. Wear safety
glasses or face shield
and hearing protection,
e.g. earplugs or ear
muffs.
Wear heavy-duty gloves.