MS 461 R
English
3
N
Mount the bar and chain – see
instruction manual of basic
chainsaw.
N
Push the guard (1) over the guide
bar and fit the screws (2).
N
Slide the depth limiter (3) onto the
guard.
N
Fit the star knob screw (4) with
washer (5).
N
Tighten down the screws (2).
N
Pull the depth limiter (3) forwards as
far as stop.
N
Tighten down the star knob (4).
The cutting depth is infinitely variable
from a few millimeters to about 20 cm.
Before adjusting the cutting depth:
N
Shut off the engine.
N
Engage the chain brake by pushing
the hand guard (1) towards the bar
nose – this locks the chain in
position.
N
Place the chainsaw on the ground,
put the heel of your right foot on the
rear hand guard and press down.
Mounting the depth limiter
3
2
4
5
3443BA030 KN
3
4
3443BA031 KN
Adjusting Cutting Depth
