![background image](http://html1.mh-extra.com/html/stihl/ms-380/ms-380_manual_1378919027.webp)
27
MS 380
English
If the engine doesn’t start:
If you did not move the Master Control
lever to the "warm start" position quickly
enough after the engine began to fire,
the combustion chamber has flooded.
:
Move Master Control (
7
) to run
position.
:
Loosen knob (
10
) in direction of
arrow.
:
Remove carburetor box cover (
11
).
:
Pull off the spark plug boot.
:
Unscrew and dry off the spark plug.
:
Set the Master Control lever to
c
:
Press down the trigger interlock
lever – open the throttle wide and
crank the engine several times with
the starter to clear the combustion
chamber.
:
Install the spark plug and connect
the spark plug boot (press it down
firmly
) – refit carburetor box cover.
:
Set Master Control lever to warm
start position – even if engine is
cold.
:
Now start the engine.
During break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
Do not make the mixture leaner to
achieve an apparent increase in
power – this could damage the
engine – see “Adjusting
Carburetor”.
Always disengage the chain brake
before opening the throttle. Running
the engine at higher revs with the
chain brake engaged (saw chain at
a standstill) will quickly damage the
engine and chain drive (clutch,
chain brake).
215BA004 KN
7
10
11
215BA005 KN
Operating Instructions