45
MS 311, MS 391
Installing
:
Position the short circuit wire so
that the yellow mark lines up with
the edge (arrow).
– Push the wiring harness (1) into
the guide.
:
Position the protective tube (2)
so that it is in line with the yellow
mark (arrow).
:
Push the protective tube (2) with
short circuit wire (1) into the
guide (centered as shown).
4903RA104 TG
1
4903RA105 TG
1
2
The wire must be laid straight and fit
snugly against the housing.
:
Push the short circuit wire (1) into
the guides (arrows).
– Install the filter base,
– Position the ring terminal (1) so
that its crimped side faces up.
:
Push the ring terminal (1) onto
the pin (arrow) as far as stop.
:
Push the short circuit wire (1) into
the guides (arrows).
4903RA103 TG
1
4903RA107 TG
1
4903RA261 TG
1
Position the short circuit wire so that
it forms a loop and can move along
with the switch shaft.
:
Check that short circuit wire is
properly seated, push it fully into
the guide (arrow) if necessary.
– Position the ring terminal (1) so
that its crimped side faces up.
:
Fit the ring terminal (1) of the
ground wire on the pin (2) and
swing it down.
4903RA109 TG
4903RA110 TG
2
1
Summary of Contents for MS 311
Page 1: ...STIH STIHL MS 311 391 2009 06 ...
Page 92: ...91 MS 311 MS 391 ...
Page 93: ...92 MS 311 MS 391 ...
Page 94: ...englisch english 0455 542 0123 M2 2 K09 FST Printed in Germany ...