MS 261 C-M
English
47
For periods of 3 months or longer
N
Drain and clean the fuel tank in a
well ventilated area.
N
Dispose of fuel properly in
accordance with local
environmental requirements.
N
Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N
Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N
If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N
Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
N
Remove chain sprocket cover, saw
chain and guide bar.
N
Release chain brake – pull hand
guard against the front handle
Fit new chain sprocket
–
after use of two saw chains or
earlier
–
if the wear marks (arrows) are
deeper than 0.02 in (0.5 mm) –
otherwise the service life of the saw
chain is reduced – use check gauge
(special accessory) to test
Using two saw chains in alternation
helps preserve the chain sprocket.
Use only STIHL original chain sprockets
to help ensure reliable functioning of the
chain brake.
N
Use a screwdriver to remove the E-
clip (1)
N
Remove the washer (2)
N
Remove rim sprocket (3) (if so
equipped), clutch drum (4) and
needle cage (6).
N
Inspect transport profile for rim
sprocket on the clutch drum (4) – if
there are also heavy signs of wear,
also replace the clutch drum
N
Remove clutch drum with integrated
spur chain sprocket (5) (if so
equipped) including needle cage (6)
from the crankshaft – for
powerheads with Quickstop Plus
chain brake system, depress
throttle trigger lockout beforehand
Storing the Machine
Checking and Replacing the
Chain Sprocket
001BA121 KN
001BA122 KN
1
2
4
5
6
1
2
3
6
Summary of Contents for MS 261 C-M
Page 2: ...Instruction Manual 1 61 Manual de instrucciones 62 128...
Page 131: ......
