![background image](http://html1.mh-extra.com/html/stihl/hl-45/hl-45_instruction-manual_1378702022.webp)
HL 45
English
20
N
Carry out the standard setting.
N
Warm up the engine.
N
Turn high speed screw (H) slightly
clockwise (leaner) – no further than
stop.
NOTICE
After returning from high altitude, reset
the carburetor to the standard setting.
If the setting is too lean there is a risk of
engine damage due to insufficient
lubrication and overheating.
Power tools with a catalytic converter
(depending on model) must be run on a
50 : 1 mixture of unleaded gasoline and
STIHL two-stroke engine oil or
equivalent two-stroke engine oil – see
chapter on "Fuel".
The catayltic converter integrated in the
muffler reduces the harmful emissions in
the exhaust gas.
The correct carburetor setting (if
adjustable) and strict observance of the
prescribed mix ratio of gasoline and two-
stroke engine oil are essential to
minimize harmful emissions and ensure
a long catalytic converter service life.
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
N
Remove spark plug – see "Starting /
Stopping the Engine".
N
Clean dirty spark plug.
N
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N
Use only resistor type spark plugs of
the approved range.
Rectify problems which have caused
fouling of spark plug:
N
Too much oil in fuel mix.
N
Dirty air filter.
N
Unfavorable running conditions,
e.g. operating at part load.
Catalytic Converter
Checking the Spark Plug
000BA039 KN
A
Summary of Contents for HL 45
Page 2: ...Instruction Manual 1 34 Manual de instrucciones 35 72 ...
Page 75: ......