Stihl GHE 355, Instruction Manual

Page: 58 / 580

0478 201 9914 E - EN
56
* Attention!
Mains fuses of less than 16 A may
frequently trip during start-up of the
machine or when it is operating under
heavy load.
1 7. 1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down ( Ö 8.8),
( Ö 10.7)
– Check power cable and fuse
#
( Ö 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician)
#
( Ö 10.1)
– Replace fuse
#
( Ö 10.1)
– Close feed chute properly and tighten
screws ( Ö 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(
Ö 11.4)
– Reset locking device ( Ö 11.7)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
– Incorrectly ground blades
– Power cable too long
– Bent blade disc
Remedy:
– Replace or re-sharpen shredding
blades (
Ö
11.9), (
Ö
11.8)
– Sharpen blades correctly
#
( Ö 11.9)
Uncertainty K
WA
2,4 dB(A)
Wheel diameter 250 mm
L/W/H 122/50/141
GHE 355.0:
Motor, design
Electric motor
(~)
Manufacturer ATB
Type BSRBF 0.75/2-C
Voltage 230 V~
Power input
2500 W
2000 W (GB)
2000 W (CH)
Fuse* 16 A
10 A (CH)
Maximum branch
diameter
35 mm
Nominal motor speed 2750 rpm
Measurement in accordance with EN
50434:
Sound pressure level
at workplace L
pA
94 dB(A)
Uncertainty K
pA
3 dB(A)
Weight 30 kg
29 kg (CH)
32 kg (GB)
GHE 355.0 / GHE 375.0:
GHE 375.0:
Motor, design Electric motor
(~3)
Manufacturer ATB
Type BSRF 0.75/2-C
Voltage 400 V~
Power input 3000 W
Fuse* 10 A
Maximum branch
diameter
40 mm
Nominal motor speed 2810 rpm
Measurement in accordance with EN
50434:
Sound pressure level
at workplace L
pA
95 dB(A)
Uncertainty K
pA
3 dB(A)
Weight 31 kg
1 8. Troubleshooting
#
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.