Stihl GHE 355, Instruction Manual

Page: 47 / 580

45
DE
FR
NL
IT
ES
PT
NO
SV
FI
DA
PL
SL
SK
HU
EN
0478 201 9914 E - EN
7. 1 Attaching wheel axle and
wheels
● Attach the wheel axle (C) with
wheel locks (E), bolts (F) and hexagon
nuts (G) to the wheel carrier (D) and
fasten with installation tool (T)
(
4 - 6 Nm ).
● Push wheel (H) onto mounted wheel
axle.
● Push in wheel plug (J) and secure by
driving in roll pin (K).
● Fit wheel cap (I).
● Repeat this procedure on the other
side.
7.2 Installing the chassis and
ejection chute
1 Install the ejection chute
extension
● Place the basic unit (A) onto a block of
wood with a height of approx. 15-
20 cm.
Risk of injury:
Do not climb onto the
machine.
Risk of injury:
Never put your hands or any
other part of your body or
clothing into the feed chute
or ejection chute.
Risk of injury!
Only insert the shredding
material on the left side.
Risk of injury!
When hard material is preselected, insert
shredding material on the left side. Note
the operating instructions.
Risk of injury!
Danger of shredding material kickback.
Keep other persons out of the danger
area. Minimum clearance 15 m.
Preselection of hard mate-
rial for shredding tree and
hedge cuttings as well as
thick branch material with
side shoots.
Preselection of soft material
for shredding organic plant
residues such as fruit and
vegetable waste, flower cut-
tings, leaves, etc.
Following actuation of the preselector
switch during operation, restarting is only
possible after 6 seconds.
6. Standard equipment
Item Designation Qty.
A Basic unit with lower chute 1
B Upper chute 1
C Wheel axle 1
D Wheel carrier 1
E Wheel lock 2
F Bolt, M6 x 55 2
G Hexagon nut 2
H Wheel 2
I Wheel cap 2
J Wheel plug 2
K Roll pin 2
L Self-tapping screw P6 x 50 2
M Discharge flap 1
N Ejection chute extension 1
O Strip 1
P Pin 2
Q Torx screw P5 x 20 3
R Torx screw P5 x 10 2
S Safety screw 3
T Installation tool 1
x
Instruction manual 1
2
7. Preparing the machine for
operation
Avoid damage to the machine.
Strictly observe all tightening
torques in the following section
"Preparing the machine for
operation" to avoid damaging the
machine.
3
4