FSA 90 R
English
15
N
Place the cutting attachment (4) on
the fanwheel (5).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
N
Fit the thrust washer (6) – convex
side must face up.
N
Fit the rider plate (7).
N
Block the shaft (8).
N
Screw the mounting nut (9) on to the
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
N
Block the shaft.
N
Unscrew the mounting nut
clockwise.
N
Take the cutting attachment and its
mounting hardware off the
fanwheel (5) – but do not remove
the fanwheel.
Power supply (mains) voltage and
operating voltage must be the same.
N
Insert the plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
6
4
5
7
8
9
3988BA016 KN
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN
