90
FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
:
Position screwdriver at the
notch of the slide (arrow) and
press in
– Slide is unlocked
:
Press throttle trigger and move
slide (arrow) until the throttle
shutter is open completely
– Push slide (arrow) in direction of
the protective tube
= Throttle cable is tensioned
(throttle shutter opens more)
– Push slide (arrow) in direction of
the trigger interlock
= Throttle cable is relieved
(throttle shutter opens less)
:
Release throttle trigger (arrow) –
the throttle trigger must return
completely to the stop in the initial
position
5904RA328 TG
5904RA329 TG
When the throttle trigger is not
actuated, the throttle cable must not
be under tension, otherwise the
throttle shutter may no longer close
completely, which would result in a
high idle speed.
– Reassemble parts in reverse
order
10.2.5 Throttle rod
– Remove the shroud,
:
Hold lever (1) and press lever (2)
of the throttle shaft in the
direction of full-throttle until the
throttle rod (3) slides out of the
lever (2)
:
Unhook the throttle rod (1) from
the lever (2)
– Check lever (2), replace if
5904RA330 TG
2
1
3
5904RA331 TG
1
2
Installation
:
Push throttle rod (1) into
hole (arrow) and hook it in
:
Hold lever (1) and push lever (2)
of the throttle shaft in the
direction of full-throttle
:
Hook throttle rod (3) into
groove (arrow) and release
lever (2)
Checking operation
– When the throttle trigger on the
control handle is pressed all the
way, the lever of the throttle shaft
must move as far as it can go in
the direction of full-throttle, adjust
throttle cable if necessary,
– Reassemble remaining parts in
reverse order
5904RA332 TG
1
5904RA333 TG
2
3
1