FS 131, FS 131 R
English
15
N
Place the secured assembly on the
handle support (8) with the wing
screw at the side nearest the
engine.
N
Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
N
Line up the handlebar at a right
angle to the drive tube – check
distance A again.
N
Tighten down the wing screw firmly.
Mounting the Control Handle
N
Take out the screw (9) – the nut (10)
remains in the control handle (11).
N
Push the control handle onto the
handlebar (7) until the holes (13)
line up – the throttle trigger (12)
must point towards the gearbox.
N
Insert the screw (9) and tighten it
down firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
N
Position the clamp (15) and handle
support (14) against the drive tube.
N
Close the throttle cable
retainer (15). The retainer (15)
snaps into place.
Adjusting the Throttle Cable
N
Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
0000-GXX-0510-A0
8
13
9
11
12
7
13
0000-GXX-051
1-A0
10
15
15
15
14
14
0000-GXX-0512-A1