BT 131
3
4.1
Clutch
4.2
Auger Brake
4.3
Gearbox
4
Troubleshooting
Condition
Cause
Remedy
Auger stops under full load
Clutch shoes badly worn
Replace clutch
Clutch drum badly worn
Install new clutch drum
Auger runs while engine is idling
Engine idle speed too high
Reset idle speed screw (LA) correctly
Clutch spring fatigued
Replace spring / clutch
Clutch spring broken
Replace spring / clutch
Loud noises
Clutch spring fatigued
Replace spring / clutch
Clutch drum bearing damaged
Replace ball bearing in clutch housing
Clutch screws loose
Tighten down screws, replace clutch if nec
-
essary and check tapped holes in flywheel,
replace flywheel if necessary
Clutch shoes worn
Replace clutch
Condition
Cause
Remedy
Auger stops under full load
Brake band jammed
Check freedom of movement and function
of brake band, replace if necessary
Auger does not stop immediately
when auger brake is engaged
Auger brake spring stretched or broken
Fit new auger brake spring
Brake band stretched, worn or broken
Replace brake band
Clutch drum worn
Install new clutch drum
Condition
Cause
Remedy
Loud noises
Ball bearings damaged or worn
Inspect bearings in clutch housing and
gearbox, replace if necessary
Pinion / output shaft or gears damaged or
worn
Replace pinion set at input and output
sides
Insufficient or no grease in gearbox and/or
clutch housing
Replace pinion set at input and output
sides
Gearbox too hot
Excessive friction due to damaged or worn
ball bearings
Inspect bearings in clutch housing and
gearbox, replace if necessary
Insufficient or no grease in gearbox and/or
clutch housing
Check pinion shaft, output shaft and gears
for damage, replace if necessary, then
pack gearbox and clutch housings with
STIHL gear grease
Gearbox runs erratically and stops
under load
Clutch worn
Inspect clutch and clutch drum, replace if
necessary
Gearbox jammed
Damaged or worn ball bearings have
seized
Inspect bearings in clutch housing and
gearbox, replace if necessary
Teeth damaged or broken – pieces are
causing blockage
Check pinion shaft, output shaft and gears
for damage, replace if necessary – always
replace both meshing components
Summary of Contents for BT 131
