46
español / EE.UU
BT 120 C
Prueba del funcionamiento del
freno de barrena
Antes de empezar a trabajar:
Con el motor funcionando a ralentí, apli-
que el freno de barrena y abra el acele-
rador completamente por no más de 3
segundos – la barrena no debe girar.
El freno de barrena está expuesto a des-
gaste normal.
Verifique que el mismo está funcionando
correctamente antes de empezar a tra-
bajar. Si el freno de barrena no funciona,
pida al concesionario STIHL que lo
repare de inmediato.
:
Apague el motor. Coloque la moto-
perforadora en el suelo con el árbol
de perforación hacia arriba.
:
Aplique el freno de barrena.
:
Extraiga el pasador de retención (
1
)
de la espiga de la barrena.
:
Empuje la barrena (
2
) en el árbol de
perforación hasta que se alineen los
agujeros (
3
).
:
Empuje el pasador de retención en
el agujero.
:
La pinza de resorte del pasador de
retención debe quedar bien ajus-
tada contra la espiga de la barrena.
:
Respete las medidas de seguridad
– vea el capítulo "Medidas de segu-
ridad".
Aplique el freno de barrena
:
Mueva la palanca a la posición
A
.
Instalación de la barrena
4
24BA006
Arranque/ parada del motor
427BA005 KN
A