24
English / USA
BT 120 C
:
Ease the cap (
5
) out of the starter
grip.
:
Remove remaining rope from the
rotor and grip.
:
Tie a simple overhand knot in the
new rope – see “Specifications” –
and then thread it through the top of
the grip and the rope bush (
6
).
:
Refit the cap in the grip.
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
:
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
:
Refit the pawl (
4
).
:
Fit the washer (
3
).
:
Install spring clip (
2
) on starter post
and engage it on the pawl's peg –
the spring clip must point clockwise.
Tensioning the Rewind Spring
:
Make a loop in the unwound
starter rope and use it to turn
the rope rotor six full revolutions
counterclockwise.
:
Hold the rotor steady – pull out and
straighten the twisted rope.
:
Release the rope rotor.
6
5
256BA033 KN
256BA034 KN
3
2
4
256BA032 KN
7
7
250BA038 KN