WORKSHOP MANUAL
MPV 320W / 520W
Chapter
5 - TRANSMISSION - WHEELS - STEERING
EDITION
2017
PAGE
25 /
64
a) Changing the oil and oil filter
1. Undo the three 1/4” screws (1) and remove
the filter guard (2). Remove any debris from
around the perimeter of the filter.
2. Place an oil collection pan (with a diameter of
about 30 cm and a capacity of 8 litres) under
the oil filter. Remove the oil filter (3) from the
transaxle.
3. After draining the oil, wipe the surface of the
filter base and apply a film of new oil on the
gasket of the new filter being installed (GGP
code 118830389/0).
4. Screw on the new filter manually, rotate by
from 3/4 of a turn to a full turn from when the
filter gasket makes contact with the surface of
the filter base.
5. Replace the filter cover (2) with three screws
(1) tightened with a torque of 7.5 Nm.
6. Remove the oil from the old filter before dis-
posal. Collect the oil in appropriate containers
and dispose of it in an approved recycling fa-
cility.
7. Remove the oil level cap (4) before pouring in
the oil, to allow air to vent during filling.
8. Remove the upper cap (5).
9. Fill with 20W50 motor oil until it reaches the
correct level. Replace the cap (4) tightening it
with a torque of 20 Nm.
10. Fit and tighten the upper cap with a torque of
over 20 Nm.
11. Bleed the system as indicated in point c).
b) Topping up the oil
When topping up with oil, remove the upper cap (5), if installed, and the level cap (4). Fill until the
oil is close to the lower edge of the level hole.
3
4
5
6
2
1
3
5
4
2
2
5
