WORKSHOP MANUAL
MPV 320W / 520W
Chapter
5 - TRANSMISSION - WHEELS - STEERING
EDITION
2017
PAGE
30 /
64
5.3 STEERING
5.3.1 Toe-in adjustment
The exact toe-in is obtained with a centre dis-
tance of 510 mm, measured between the centres
of the pins (1) of the wheel connection rod (2).
If the measurement differs, proceed as follows.
1. Unscrew the nuts (3) and disconnect each
head (4) from the connection rod (2).
2. Loosen the lock nuts (5) and screw or unscrew
the heads (4) on the rod, until the indicated
distance is achieved.
3. Remount the rod and fully tighten the nuts (3)
and lock nuts (5).
5.3.2 Adjusting the drive direction
This adjustment must be carried out if the machine tends to deviate its trajectory to the right or left
with the steering wheel straight.
• Check the toe-in
[
;
• Align the rear wheels.
1. Unscrew the nut (1) and remove the head (2).
2. Loosen the lock nut (3) and screw or unscrew
the head (2) on the steering rod (4), until the
steering wheel is aligned.
3. Remount the rod and fully tighten the nuts (1)
and lock nuts (3).
510 mm
1
1
2
1
3
2
4
3
4
5
2
