Stiga BLV 20 Li A, Operator'S Manual

Page: 19 / 31

EN - 5
its specifications and operating instructions
are described in a specific manual.
L. Battery charger (if not supplied with
the machine, see chapter 13 “optional
accessories"): device used to recharge the
battery; its characteristics and operating
instructions are described in a specific
manual.
3.3 PRODUCT IDENTIFICATION
LABEL (Fig. 1)
1. Sound power level
2. Conformity marking
3. Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
8. Power supply voltage and frequency
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
IMPORTANT Quote the information on the
product identification label whenever you contact
an authorised service workshop.
IMPORTANT The example of the Declaration of
Conformity is provided on the last pages of the
manual.
3.4 SAFETY SIGNS (Fig. 2)
Several symbols are displayed on the machine.
Meaning of symbols:
WARNING! DANGER! The
failure to use this machine
correctly can be hazardous
for oneself and others.
WARNING! Read the
instruction manual before
using the machine.
Use ear protection
devices and goggles.
Do not leave the machine in the
rain (or in damp conditions)
PROJECTION HAZARD! Pay
attention to possible flying debris
projected by the air flow: they can
cause serious injuries to persons
or damage to objects.
PROJECTION HAZARD! Keep
any people or pets at least 15 m
away when using the machine!
Remove the battery before
carrying out any inspection,
cleaning or maintenance/
adjustment work on the machine.
Fan blades
Rotating fan blades can cause
serious injury.
Do not touch the fan when the
tool is in use
IMPORTANT Damaged or illegible labels must
be replaced. Order replacement decals from an
authorised assistance centre.
4. ASSEMBLY
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and final assembly must
be carried out on a flat, solid surface with
sufficient space to facilitate the movement of
the machine and its packaging, always using
the right tools. Do not use the machine until all
the indications provided in the “ASSEMBLY”
section have been carried out.
4.1 UNPACKING
1. Carefully open the packaging, paying attention
not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.