Stiga 13-7454-11, Workshop Manual

Page: 42 / 123

6. Thread the collar onto the bar (do not
forget the circlip and O ring if they
have been removed).
7. Apply Loctite 270 to the piston and the
threads of the shaft (not so much that
it runs).
8. Thread on the piston.
9. Tighten the piston to a torque of 240
Nm, if over-torqued the thread can be
stripped and if under-torqued the pis-
ton can work loose over time.
10. Apply a little oil around the pipe, on
the piston seal and the collar O-ring.
11. Install the piston and collar in the pipe.
12. Install the circular locking rings
13. Pull out the bar to its maximum posi-
tion.
14. Press in the O ring between the collar
and the cylinder pipe.
15. Install the circlip.
16. Ready for use.
Note Any guarantees are invalidated
if the cylinder has been disman-
tled.
WORKSHOP MANUAL
TITAN
Chapter
3 - Steering system
EDITION
2018
Page
40