iNSTAllATiON
Specification
www.stiebel-eltron.com
SHP-A 220-300 Plus |
31
EN
GL
ISH
A1
Electronic assembly (control unit)
A2
Electronic assembly (programming unit)
C1
Condenser
E1
Heating element
F1
High limit safety cut-out TSR
F2
Motor overload relay M1
F3
High pressure limiter
F4 Fuse
G1
Impressed current anode
M1 Compressor
M2 Fan
N1
Thermostat TSR
R1 Resistance
S1
DIP switch
S2
DIP switch
T1
Temperature sensor (cylinder top/integral)
T4
Temperature sensor, evaporator
X0
Mains terminal
X1 Terminals
X3 Terminals
Behälter Cylinder
Deckel Cover
Mantel Jacket
16.3 Fault conditions
WARNING Burns
In the case of a fault, temperatures up to the high limit
safety cut-out limit can occur (see "Specification / Data
table" chapter).
16.4 Data table
SHP-A 220 Plus
SHP-A 300 Plus
SHP-A 300 X
Plus
238633
238634
238635
Hydraulic data
Nominal capacity
l
220
302
291
Surface area, indirect coil
m²
1.3
Application limits
Max. DHW temperature with heat pump
°C
65
65
65
Max. DHW temperature with emergency/booster heater
°C
65
65
65
Max. permissible DHW temperature inside the cylinder
°C
70
High limit safety cut-out
°C
92
92
92
Min./max. application limits for heat source
°C
+6/+42
+6/+42
+6/+42
Minimum installation room volume (recirculation air mode, general do-
mestic use)
m³
23
23
23
Maximum permissible operating pressure, cold water/DHW
MPa
0.8
0.8
0.8
Min./max. conductivity, drinking water
μS/cm
100-1500
100-1500
100-1500
Output data to EN 16147
Nominal DHW temperature (EN 16147)
°C
55
55
55
Nominal load profile (EN 16147)
L
XL
XL
Reference DHW temperature (EN 16147 / A20)
°C
52.6
54.4
54.4
Reference DHW temperature (EN 16147 / A15)
°C
52.7
54.1
52.5
Reference DHW temperature (EN 16147 / A7)
°C
54.0
54.2
52.6
Maximum available nominal amount of DHW at 40 °C (EN 16147 / A20)
l
278
395
371
Maximum available nominal amount of DHW at 40 °C (EN 16147 / A15)
l
277
412
387
Maximum available nominal amount of DHW at 40 °C (EN 16147 / A7)
l
254
410
381
Rated heating output Prated (EN 16147/A20)
kW
1.6
1.52
1.43
Rated heating output Prated (EN 16147 / A15)
kW
1.45
1.63
1.41
Rated heating output Prated (EN 16147 / A7)
kW
1.01
1.14
1.07
Heat-up time (EN 16147 / A20)
h
6.06
9.05
9.05
Heat-up time (EN 16147 / A15)
h
6.65
8.83
9.60
Heat-up time (EN 16147 / A7)
h
8.78
12.52
12.43
Power consumption, standby period (EN 16147 / A20)
kW
0.022
0.024
0.028
Power consumption, standby period (EN 16147 / A15)
kW
0.027
0.028
0.032
Power consumption, standby period (EN 16147 / A7)
kW
0.035
0.040
0.044
COP (EN 16147 / A20)
3.55
3.51
3.51
COP (EN 16147 / A15)
3.20
3.26
3.30
COP (EN 16147 / A7)
2.68
2.79
2.75
Heating output
Average heating output (A20 / W10-55)
kW
1.9
1.9
1.9
Average heating output (A15 / W10-55)
kW
1.6
1.6
1.6
Average heating output (A7 / W10-55)
kW
1.3
1.3
1.3
