OPERATION
Cleaning, care and maintenance
EN
GL
ISH
www.stiebel-eltron.com
DCE 11/13 |
21
The wireless remote control is normally in power save mode,
which means the display is switched off. Pressing any key activates
the wireless remote control, the temperature display appears. The
progress bar indicates that data is being transmitted to the device.
If no key is pressed within 10 seconds the wireless remote control
automatically switches back to power save mode.
The selected temperature is also maintained in power save mode.
Saving temperature to memory keys
f
f
Select a preferred temperature.
f
f
Press memory key 1 or 2 for two seconds. The temperature
display flashes once to confirm.
f
f
You can turn the appliance's heater off (display message
OFF). Press the "-" button once, which will result in a setting
of 20 °C.
Battery change
1
+
-
2
D
00000
47
484
1
1 Battery change symbol
When the battery symbol illuminates, change the battery of the
wireless remote control. A change of battery may also become
necessary when the temperature settings are not received by the
device and/or the transmission range decreases.
!
Material losses
f
f
Remove the old battery.
Any damage caused by a leaking battery is excluded from
any warranty.
f
f
Open the casing of the wireless remote control by unscrew-
ing the 4 screws on the underside of the device.
f
f
Replace with a CR 2032-type battery. Never install rechargea-
ble NiCd batteries. Ensure correct polarity of the new battery
(+ at the top).
f
f
Put the case back together and re-tighten the four screws.
When reassembling the casing, do not damage the sealing
gasket.
The stored values for keys 1 and 2 will be retained while the bat-
tery is being changed.
Disposing of the battery
Never dispose of batteries with domestic waste. Spent
batteries contain hazardous substances that are detri-
mental to the environment and human health. Dispose
of batteries through your dealer or via a central recycling
point for special waste.
4.3 Anti-scalding protection / temperature limit
When activating the anti-scalding protection the DHW temperature
can only be set between 20 °C and 43 °C.
Higher temperature settings are not implemented.
Use the anti-scalding protection in locations such as child nurs-
eries, hospitals, care homes etc.
Note
The qualified contractor can activate the anti-scalding
protection in your appliance (see chapter "Installation /
Installation / Anti-scalding protection / Temperature lim-
iter").
4.4 Following an interruption of the water supply
See chapter "Installation / Commissioning / Restarting".
5. Cleaning, care and maintenance
f
f
Never use abrasive or corrosive cleaning agents. A damp
cloth is sufficient for cleaning the appliance.
f
f
Check the taps regularly. Limescale deposits at the spouts
can be removed using commercially available descaling
agents.
f
f
Have the electrical safety of the appliance regularly checked
by an electrician.
