OPERATION
Appliance description
20
|DCE 11/13
www.stiebel-eltron.com
2.3 CE designation
The CE designation shows that the appliance meets all essential
requirements according to the:
- Low Voltage Directive
- Electromagnetic Compatibility Directive
The maximum permissible mains impedance is indicated in
chapter "Installation / Specification / Data table".
2.4 Test symbols
See type plate on the appliance.
Country-specific approvals and certifications: Germany
In line with [German] State Building Regulations, a general test
certificate has been issued for the appliances, as verification of
their suitability regarding noise emissions.
DIN 4109
P-IX 16726/I
3. Appliance description
The electronically controlled compact instantaneous water heater
maintains a constant outlet temperature up to its output limit,
irrespective of the inlet temperature.
The appliance warms the water directly at the draw-off point, as
soon as you turn on the hot water tap. The short pipe runs ensure
that energy and water losses are minimal.
For the start flow rate, see "Installation / Specification / Data
table".
The DHW output depends on the cold water temperature, the
heating output, the flow rate and the set temperature required.
DHW temperature
The DHW outlet temperature can be variably adjusted.
Heating system
The bare wire heating system is suitable for hard and soft water
areas. This heating system has a low susceptibility to scale build-
up. The heating system ensures quick and efficient DHW provision.
Note
The appliance is equipped with an air detector that large-
ly prevents damage to the heating system. If, during op-
eration, air is drawn into the appliance, the heater shuts
down automatically for one minute, thereby protecting
the heating system.
4. Settings
4.1 DCE 11/13
Operation
°C
40
50
60
30
20
D
00000
39
98
9
1
1 Temperature selector: Temperature setting range
20 °C – 60 °C
4.2 DCE 11/13 RC
The FFB 4 wireless remote control allows you to change the tem-
perature setting by wireless control. The selected temperature is
displayed on the remote control unit.
The wireless remote control unit supplied is registered to the re-
ceiver module. Only a registered remote control unit can alter the
settings on the appliance.
The wireless range is reduced by obstacles between the appliance
and the remote control.
You can mount the wireless remote control anywhere using the
wall mounting bracket supplied in the standard delivery.
Operation
1
+
-
2
D
00000
39
99
0
2
1
3
1 Display
2 Temperature setting 20 °C – 60 °C in 0.5 °C steps, using the +
and - buttons
3 Memory keys 1 and 2.
